high shear

英 [haɪ ʃɪə(r)] 美 [haɪ ʃɪr]

网络  高剪切; 高剪力

化学



双语例句

  1. Agglomeration Kinetic Model of Nano-alumina Trihydroxide in Carbonation via Viscosity at High Shear Rate
    通过高剪切粘度建立碳分过程中纳米ATH的附聚动力学模型
  2. High shear resistance, no edge warp, using structural separating paper.
    高抗剪切力,不会翘边,使用结构型离型纸。
  3. Indeed, W/ O emulsions require high shear homogenisation and then specific device to get stable formulations.
    的确,w/型乳剂要求高以及获取稳定配方的特殊仪器。
  4. Functionalization of ethylene propylene diene monomer with maleic anhydride in melt state through high shear stress-induced initiation
    高剪切应力诱导引发马来酸酐官能化三元乙丙橡胶
  5. Strong adhesion, high shear resistance, no residue left when removed, using structural separating paper. It's used for mounting photo sensitive resin plate on printing roller or resin sleeve.
    高粘性,高抗剪切力,揭处不留残胶,使用结构型离型纸,固定感光树脂版于印刷辊筒及树脂套筒上。
  6. With its high shear rate and equipped with a water pouring system, the twin screw extruder could be applied to recycle above mentioned materials.
    利用挤出机高剪切、可注水的功能实施体型高分子的分解,从而制得性能优良的再生塑料。
  7. The occurrence of high shear stress at the fibre end is a factor which is expected to lead to crack generation.
    在纤维端部存在高切变应力视为导致产生裂缝的因素。
  8. The experimental results show that this acid system has good adhesion, and the acid system is steady in high temperature and high shear, and has good steering performance and fluid loss performance.
    实验结果表明该型酸液体系具有良好的变粘性,高温高剪切下酸液体系稳定,有着较好的转向性能和降滤失性能。
  9. Numerical Simulation of Three-dimensional Flow Based on High Shear Pump for Ink Mixing
    基于高剪切泵油墨混合的三维流场数值模拟
  10. Influence of process parameters of high shear granulation on the solidification of oily drug vitamin E
    高剪切技术工艺参数对维生素E颗粒形成的影响
  11. After curing the product can possess the merits of high shear strength, high strip strength, good toughness, good elasticity, waterproof, climate-endured, anti-chemical erosion, no causticity, etc.
    固化后高剪切、高剥离强度、韧性好、弹性好、防水、耐气候、抗化学侵蚀和无腐蚀性等优点。
  12. At high shear rate, apparent viscosity of the blends became small and reached to that of POM.
    随着剪切速率的提高,共混物剪切黏度迅速与POM接近。
  13. Coating rheological properties in high shear coating process and the influence of different kinds of binders were studied. A way to forecast the coating flow stability in the coating process was introduced.
    研究了涂料在高剪切涂布过程中的流体特性及不同胶粘剂的影响,同时还介绍了预测涂布过程涂料流动稳定性的方法。
  14. Determination of Lubricant Elastic Shear Modulus under Conditions of High Pressure and High Shear Rates
    高压高剪切率下润滑剂剪切弹性模量的确定
  15. Under the conditions of simulated penetration and high shear in formation, the reservation rate of its viscosity can be above 60%.
    在模拟炮眼和地层的高速剪切条件下,其粘度保留率可以达到60%以上,具有较强的抗剪切性能。
  16. Study of Coating Rheological Properties in High Shear Coating Operation
    在高剪切涂布过程中涂料流变性的研究
  17. Usually the core of sandwich is made from light material with high shear modulus.
    夹层结构的芯材是具有一定抗剪刚度的轻质材料。
  18. The CMA-treated soils have a high shear strength and unconfined compressive strength whether saturated or not, and possess better water stability.
    在非饱水和饱水状态下,改性土都具有较高的抗剪强度和无侧限抗压强度,说明改性后其水稳定性较好。
  19. Experimental results show: high viscosity, elasticity, high shear and small disc gap were advantageous to mixing;
    实验结果表明:高粘、弹性、高剪切和小的盘间距有利于混合;
  20. The results showed that the denatured effect was not obvious by cell's pulverizer and high shear emulsification machine.
    试验表明:运用细胞粉碎机和高剪切乳化机作用于活性污泥,改性效果不明显;在pH7.0左右,对活性污泥的改性改性效果最好。
  21. Moisture-curable pressure sensitive adhesives with high shear strength were prepared with acrylic monomer as raw material.
    以丙烯酸类单体为原料制备了一种具有较高剪切强度的湿固化型压敏胶。
  22. The formula for calculating the elastic shear modulus of rollers with lubricant under conditions of high pressure and high shear rates was presented.
    给出了高压高剪切率下滚子-润滑膜系统有效剪切弹性模量的计算公式;
  23. It is found that the initial slip length controls the slip behavior at small shear rate, but the critical shear rate controls the boundary slip at high shear rate.
    研究发现初始滑移长度对低剪切率下的滑移行为起主要作用,而临界剪切率决定了高剪切率下的边界滑移程度。
  24. The thermoplastic elastomer had good flowability under high shear rate, and reasonable mechanical properties.
    PP/PBA热塑性弹性体在高剪切条件下具有良好的流动性,而且在非极性溶剂中具有较低的溶胀度。
  25. High shear stress inhibited Lip production.
    高剪应力对酶活有抑制作用。
  26. Experimental Study on Drilling Fluid Viscosity under High Shear Rate
    高剪切速率下钻井液粘度的实验研究
  27. Red clay also shows low compactibility and high shear strength and bearing capacity in geotechnical engineering.
    在工程中,红粘土具有压实性较差和较高的抗剪强度与承载力的特点。
  28. Moderate Earthquakes occurred in the research zone were mainly located at the high-low stress transition region and the region with high shear stress and high shear stress gradient.
    研究区的中强地震主要发生在高、低应力值的过渡区,剪应力的高值区或是剪应力的相对高梯度带。
  29. ( 3) A method to synthesize PMMA-grafted MWNTs via emulsion free radical polymerization under high shear was investigated.
    研究了一种在高剪切条件下,用乳液自由基聚合法制备PMMA接枝MWNTs的方法。